Beatbot AquaSense 2 review: which model is five-in-one
The Beatbot AquaSense 2 is the entry point to Beatbot's flagship pool cleaning line, and its published specification lists three cleaning zones: floor, walls and waterline. The five-in-one routine that often gets attached to the AquaSense name belongs to the Pro and Ultra models further up the range, not to the base unit. This article is a specification-and-fit analysis rather than a hands-on test. Every figure below comes from the published product pages, and where a number is not published, it is left out instead of estimated.
That distinction matters. Read model by model, the range splits into a three-zone cleaner, two five-zone cleaners with clarification, and a station-equipped flagship.
What the base AquaSense 2 is documented to clean
The AquaSense 2 listing describes a three-in-one system covering floor, walls and waterline, with dual-pass scrubbing at the waterline. There is no water-surface skimming mode and no clarification dosing on this model. If surface debris is your main complaint, the base AquaSense 2 is not the machine that solves it.
The published hardware is otherwise substantial for the money. Suction is listed at 5,500 GPH, the battery at 10,000 mAh lithium-ion, and floor-cleaning runtime at up to 4 hours continuous. Filtration is 150 micron, coverage is quoted at up to 3,230 sq ft (300 m2), and the unit weighs 10.47 kg (23.08 lb). Navigation runs on CleverNav with SonicSense ultrasonic pool mapping, drawing on 16 sensors including 2 ultrasonic. Recharging takes about 4 hours on the wireless dock, and the listing shows a 3-year full machine replacement warranty.
At $799 at the time of writing, the Beatbot AquaSense 2 Robotic Pool Cleaner is priced as a serious cordless floor-and-wall cleaner with waterline capability, and that is how it should be judged.
The AquaSense 2 Pro is where five-in-one actually starts
The Pro listing is explicit about a five-in-one system: water surface, floor, walls and waterline, plus built-in water clarification. Those are the five, and they are why the Pro exists as a separate product.
Suction stays at 5,500 GPH, but the battery grows to 13,400 mAh. Surface cleaning runs up to 11 hours and floor cleaning up to 5 hours, with coverage up to 3,875 sq ft (360 m2). Filtration remains 150 micron, the debris basket holds 3.7 L, and the machine runs 9 motors at 11.38 kg (25.08 lb). Charging takes about 4.5 hours, and the listing rates it for saltwater up to 5,000 ppm under the same 3-year full machine replacement warranty. The Beatbot AquaSense 2 Pro AI Robotic Pool Cleaner is listed at $2,299, though it moves in and out of stock, so check current availability on the product page before planning around it.
What the AquaSense 2 Ultra changes, and one number worth checking
The Ultra listing states that it cleans the water surface, floor, walls and waterline and adds automatic water clarification, the same five-part description as the Pro. What changes is the sensing and the hardware count. Navigation moves to HybridSense AI pool mapping working alongside CleverNav, motor count rises to 11, and the machine ships with two basket options at 4.0 L and 3.7 L, with 150 and 250 micron media listed.
Here is the number that deserves a second look. Battery capacity matches the Pro at 13,400 mAh, but published coverage per charge is up to 3,444 sq ft (320 m2), below the Pro's 3,875 sq ft. Weight rises to 13.2 kg (29.1 lb) and charging takes about 4.5 hours. The Ultra is the more instrumented machine; the Pro is the one with the longer quoted reach per charge. At $2,199 the Beatbot AquaSense 2 Ultra AI Robotic Pool Cleaner also sits below the Pro on price. On a large pool, that coverage comparison matters more than the model name.
Where the AquaSense X sits above the range
The AquaSense X is a different proposition rather than a faster AquaSense 2. Its listing quotes 7 smart cleaning modes, 6,800 GPH suction, and a 13,400 mAh battery delivering up to 10 hours of surface cleaning and up to 5 hours each on floors and on walls and waterline. Coverage is up to 3,875 sq ft per charge, filtration up to 150 micron, and it runs 11 motors.
Sensing is the headline. The X uses HybridSense with 29 sensors combining an AI camera, infrared and ultrasonic, with detection of 40-plus debris types and voice smart-home control. It also adds a self-cleaning station, which is why the robot is quoted at 28.9 lb and the station separately at 41.9 lb. Charging takes about 4.5 hours at 88W, and warranty is 3-year full machine replacement. The Beatbot AquaSense X AI Robotic Pool Cleaner is listed at $3,999.
How the Sora 70 compares on paper
Anyone shopping the AquaSense line should look sideways at the Sora 70 first. Its listing quotes 5 cleaning modes across water surface, floor, walls, waterline and shallow platforms, one zone more than the Pro description covers. Suction is 6,800 GPH, matching the AquaSense X and exceeding the 5,500 GPH quoted across the AquaSense 2 models.
The trade-offs show up elsewhere. Battery is 10,000 mAh rather than 13,400 mAh, runtime is up to 7 hours on the surface, up to 5 hours on floors and up to 4.5 hours for a full clean across all five zones, and coverage is up to 3,230 sq ft. Filtration is 150 micron with an optional 3-micron ultra-fine filter, and warranty is 3-year limited manufacturer coverage. At $1,099, currently sold as a pre-order, the Beatbot Sora 70 Robotic Pool Cleaner holds the most interesting price-to-zone ratio in the family.
The range side by side, and which pool each one fits
Every figure below is taken from the product listing for that model, ordered by price.
| Model | Price | Cleaning zones as listed | Suction | Battery | Coverage per charge |
|---|---|---|---|---|---|
| Beatbot AquaSense 2 Robotic Pool Cleaner | $799 | Floor, walls, waterline (described as 3-in-1) | 5,500 GPH | 10,000 mAh | Up to 3,230 sq ft |
| Beatbot Sora 70 Robotic Pool Cleaner | $1,099 | Water surface, floor, walls, waterline, shallow platforms | 6,800 GPH | 10,000 mAh | Up to 3,230 sq ft |
| Beatbot AquaSense 2 Ultra AI Robotic Pool Cleaner | $2,199 | Surface, floor, walls, waterline, clarification | 5,500 GPH | 13,400 mAh | Up to 3,444 sq ft |
| Beatbot AquaSense 2 Pro AI Robotic Pool Cleaner | $2,299 | Surface, floor, walls, waterline, clarification | 5,500 GPH | 13,400 mAh | Up to 3,875 sq ft |
| Beatbot AquaSense X AI Robotic Pool Cleaner | $3,999 | 7 smart cleaning modes | 6,800 GPH | 13,400 mAh | Up to 3,875 sq ft |
Warranty, dealer status and what the support actually covers
The AquaSense 2, Pro, Ultra and X listings all state a 3-year full machine replacement warranty, and the Sora 70 lists 3-year limited manufacturer coverage. Buying from an authorized dealer keeps that intact. RoboticsSelect is an authorized Beatbot dealer, so units ship with the full manufacturer warranty, free shipping and weekday phone support, 9am to 5pm EST.
The optional Beatbot Extended Warranty for AquaSense Pro at $399 applies to the AquaSense Pro, AquaSense 2 Pro, AquaSense 2 Ultra, AquaSense X, Sora 30 and Sora 70. It covers motors, electronics, the water-clarification system and the chassis, including the AquaRefine dispenser hardware, though refill chemicals are excluded. It must be bought within 30 days of the original purchase and transfers once. One caution: the coverage length on the extended warranty page does not read the same as the term printed on the cleaner listings, so confirm it with support first.
Start with the debris you are fighting. A pool under leaf cover collects floating material a floor-and-wall cleaner will never reach, which makes surface cleaning the deciding capability: the Pro, the Ultra, the X or the Sora 70. Fine settled silt is a different problem, and the base AquaSense 2 handles it at a fraction of the flagship price.
Size sets the second constraint, so measure your surface area against the coverage column before assuming the cheapest model is short. Weight sets the third: the range climbs from 10.47 kg to 13.2 kg, and you lift that machine out every time.
Frequently asked questions
Is the Beatbot AquaSense 2 a five-in-one cleaner?
No. The base AquaSense 2 listing describes a three-in-one system covering floor, walls and waterline. Five-in-one is the description used for the AquaSense 2 Pro and the AquaSense 2 Ultra, which add water-surface cleaning and water clarification to those three zones. Five-in-one attached to the AquaSense 2 name almost always refers to one of those two models.
What is the difference between the AquaSense 2 Ultra and the Pro?
Both are described with the same five capabilities. The Ultra moves to HybridSense AI pool mapping alongside CleverNav, runs 11 motors instead of 9, and ships with baskets at 4.0 L and 3.7 L in 150 and 250 micron media. The Pro quotes higher coverage per charge, 3,875 sq ft against 3,444 sq ft, and is lighter at 11.38 kg against 13.2 kg.
How does the Beatbot Sora 70 compare with the AquaSense 2?
The Sora 70 covers five zones including shallow platforms, against three on the AquaSense 2, and quotes higher suction at 6,800 GPH against 5,500 GPH. Both list a 10,000 mAh battery and 3,230 sq ft coverage. The Sora 70 costs more at $1,099 and is sold as a pre-order, so availability rather than capability is the practical difference.
Does an AI pool cleaner need a booster pump or a hose connection?
Not in this range. Every Beatbot model here is a self-contained cordless machine carrying its own battery and filtration, so it does not tap the pool's circulation system and needs no booster pump or hose run to a skimmer port. You charge it, drop it in, and lift it out.
Are Beatbots sold here covered by the manufacturer warranty?
Yes. RoboticsSelect is an authorized Beatbot dealer, so every unit carries the coverage stated on its listing: 3-year full machine replacement across the AquaSense models and 3-year limited manufacturer coverage on the Sora 70. Authorized purchase also matters for parts, since consumables such as filter baskets and roller brushes are stocked as genuine Beatbot components.
Seeing the full range before you commit
The AquaSense name spans two very different capability sets, and the model number tells you which one you are buying. Compare published coverage against your pool's surface area, decide whether floating debris is part of the problem, and the choice narrows quickly. The full Beatbot pool cleaner range at RoboticsSelect lists current pricing, 0% APR financing and free shipping.