Skip to main content Skip to content

Buying Guides

Maximize Your Pool Care with WYBOT Bundles

6 min read
WYBOT F1 solar robotic pool skimmer collecting leaves on the water surface

Each WYBOT Full Pool Solution bundle pairs an underwater cleaner with the F1 solar surface skimmer, so two robots handle the floor and the surface at the same time. RoboticsSelect carries seven of these bundles, and this guide explains what the F1 adds, how to choose the underwater partner for your pool, and what living with two robots involves week to week.

Key takeaways

  • Every bundle includes the F1, a solar skimmer with a 7-liter basket, a 180 micron filter, and two modes: Smart, which runs for 24 hours, and Standard, which runs for 8.
  • The underwater partner sets the coverage below: the A1 is floor-only, while every other cleaner in the bundle range also cleans walls and the waterline.
  • Rated pool sizes run from about 1,076 square feet for the A1 & F1 to about 3,230 square feet for the S2 & F1.
  • Warranty is split by robot: the bundle listings show 1 year on the F1, 1 year on the A1 and B1, and 2 years on the other five cleaners.

What does the F1 add to an underwater cleaner?

An underwater robot cleans what has already sunk. The F1 works the layer above it, floating on the surface and catching leaves, bugs, pollen, hair, and twigs before they ever reach the floor. Its solar panel charges it while it floats in sunlight, and its obstacle avoidance steers it around toys and ladders on its own.

The two machines split the job rather than duplicate it. With the surface skimmed through the day, less debris settles for the underwater cleaner to collect, and WYBOT says the pool's own filter and pump get an easier time as well. An anti-backflow baffle keeps what the F1 catches inside its basket, which WYBOT puts at about 30 percent larger than typical skimmers.

Choose the F1's mode to suit the day. Smart Mode alternates work and rest over a full 24 hours, Standard Mode skims nonstop for 8 hours, and the EdgeMaster behavior takes the skimmer along the walls, where floating debris tends to gather.

WYBOT C2 cordless robotic pool cleaner high-efficiency cleaning
In the C2 bundles, the cleaner handles the floor, walls, waterline, steps, and slopes.

Which underwater cleaner should you pair with the F1?

Because the F1 is identical in every bundle, choosing a bundle really means choosing the underwater cleaner. The table summarizes what each pairing's bundle listing states for the cleaner below the surface.

Bundle Underwater cleaner covers Rated pool size Cleaner runtime
A1 & F1 Floor only (flat bottom, slope under 15 degrees) About 1,076 sq ft Up to 120 min
B1 & F1 Floors, walls, waterline, steps, slopes About 1,150 sq ft Up to 120 min
C1 & F1 Floors, walls, waterline, steps, slopes About 1,615 sq ft 120 to 150 min
C2 & F1 Floors, walls, waterline About 2,152 sq ft Up to 180 min (Eco)
C2 Vision & F1 Floors, walls, waterline, with AI camera targeting on the floor About 2,152 sq ft Up to 180 min (Eco)
S2 & F1 Floors, walls, steps, waterline About 3,230 sq ft Up to 210 min
S2 Solar Vision & F1 Full pool, with AI camera targeting on the floor About 3,229 sq ft 2.5+ hours, recharging on a solar dock

Small flat-bottom pool, floor debris only

The A1 & F1 bundle is the entry pairing for flat-bottom above-ground or in-ground pools. Its cleaner works the floor on 120-minute cycles and pauses at each wall to clean the edge, but it never leaves the floor, so the walls and waterline stay a manual job.

Small pool where the walls need scrubbing too

The B1 & F1 bundle keeps the cleaner small and light while adding walls, waterline, steps, and slopes. The B1's patented edge-to-edge side brushes reach into corners, and its five app modes include a Waterline-only option.

Mid-size pool, or a pool that collects fine dust

The C1 & F1 bundle gives full floor, wall, and waterline coverage for mid-size pools. Move up to the C2 & F1 bundle for a larger pool or for fine debris: the C2's second filter layer works down to 10 micron, and the bundle listing points to pools that gather dust and silt.

Trees overhead and uneven debris

The C2 Vision & F1 bundle shares the C2's rating and adds an onboard AI camera that finds debris and concentrates on the dirtiest parts of the floor, with WYBOT rating its AI Vision floor mode at up to 20 times faster. The listing aims it at pools under real debris pressure, such as trees overhead or wind-blown dust, where the F1 intercepts what floats and the camera hunts what sinks.

Large pool where runtime or charging is the limit

The S2 & F1 bundle suits long or busy pools that need complete coverage in one cycle rather than two. The S2 Solar Vision & F1 bundle goes further: its cleaner recharges on an underwater solar dock with DC backup, so both robots in the pairing draw their power from the sun. The S2 Solar Vision listing specifies in-ground pools, since the dock sits at the waterline.

WYBOT F1 solar skimmer working along the pool edge
The F1 solar skimmer covers the surface between the cleaner's cycles.

Running two robots: the weekly routine

Both robots run from the WYBOT app. Add the cleaner and the F1, float the skimmer and choose its mode, then pick a cleaning mode for the cleaner and start its underwater cycle; weekly schedules for the cleaner keep the floor on a set rhythm while the F1 handles the surface in between.

The two charge differently. The F1 arrives with a factory charge and tops up from the sun while it floats; an optional DC charger, sold on its own, adds quicker or indoor charging. The cleaners in most bundles charge from their included chargers between cycles, while the S2 Solar Vision returns to its dock by itself whenever its battery dips below 20 percent.

Two baskets now need attention instead of one. Empty and rinse the F1's basket and filter when it fills, rinse the cleaner's filters after its cycles, and store the cleaner shaded and dry when it is out of the water.

Bundle or separate purchase?

If you already own a WYBOT cleaner that suits your pool, the missing piece may be the surface alone. RoboticsSelect sells the F1 skimmer on its own, so a working cleaner does not need replacing to gain skimming. For a new setup, a bundle settles both choices in one order; compare its product card with the cleaner and the F1 bought separately, since prices change and the cards show what is current.

Before you buy

Choose the underwater cleaner first, because the F1 is the same in every bundle. Check your pool's size against the cleaner's rating, decide whether the walls and waterline need automated cleaning, and confirm the pool is in-ground if the S2 Solar Vision pairing is on your shortlist.

Warranty, shipping, and support

The bundle listings set warranty by robot. The A1 and B1 cleaners carry 1-year manufacturer warranties, the C-series and S-series cleaners (C1, C2, C2 Vision, S2, S2 Solar Vision) carry 2 years, and the F1 carries 1 year. Wear items such as filters, brushes, and rollers are excluded, along with cosmetic damage, misuse, improper maintenance, and unauthorized modification, and warranty service needs a valid proof of purchase.

RoboticsSelect is an authorized WYBOT dealer, so a claim on either robot comes to our support team, which works it through with WYBOT. Bundles ship free within the contiguous 48 states; we do not ship to PO boxes, Alaska, Hawaii, Puerto Rico, or abroad. The 30-day return window in our refund policy covers unopened, unused units, and you can reach our product-trained team in the U.S. through support@roboticsselect.com or at (412) 415-7375.

The takeaway

A WYBOT bundle earns its place when floating debris is part of the problem: the F1 takes the surface and the cleaner you choose takes everything below it. Pick that cleaner by pool size, floor shape, and whether the walls matter, then compare every pairing in the pool cleaner bundles collection.

Products in this article

FAQ

Does the F1 skimmer need to be plugged in to charge?

The F1 charges from its 33 watt solar panel while it floats in sunlight, and it arrives with a factory charge. For quicker top-ups or charging indoors, an optional DC charger is available separately.

Can both robots in a WYBOT bundle run from one app?

Yes. Each bundle is set up by adding both the cleaner and the F1 skimmer to the WYBOT app, where you choose the F1 mode and schedule the cleaner for weekly cycles.

Do the cleaner and the F1 carry the same warranty?

The bundle listings show a 1-year warranty on the F1 and on the A1 and B1 cleaners, and 2 years on the C-series and S-series cleaners. Filters, brushes, and rollers are wear items and are excluded.

Which WYBOT bundle suits a pool under trees?

The C2 Vision and F1 bundle is described for pools with heavy debris such as trees overhead: the F1 intercepts floating leaves and the C2 Vision camera targets the dirtiest areas of the floor. For a large in-ground pool, the S2 Solar Vision and F1 bundle pairs an AI camera with a solar charging dock.

Can the F1 be bought without a cleaner?

Yes. RoboticsSelect sells the WYBOT F1 on its own, so an owner whose WYBOT cleaner already suits the pool can add surface skimming without replacing it.