Robotic Pool Cleaners
How WYBOT Products Transform Pool Maintenance
WYBOT makes cordless underwater pool cleaners, a solar surface skimmer, and a cleaner that recharges itself at a solar dock, and each one takes a different chore off a pool owner's list. This overview goes through those chores one at a time, shows which WYBOT product RoboticsSelect carries for each, and is clear about the upkeep that stays with you.
Key takeaways
- WYBOT's underwater range runs from the floor-only A1, rated for flat-bottom pools up to about 1,076 square feet, to the S2, rated for pools up to 3,230 square feet with up to 210 minutes per charge.
- The B1, C1, C2, C2 Vision, S2, and S2 Solar Vision clean walls and the waterline as well as the floor; the A1 stays on the floor.
- The F1 skimmer runs on a 33 W solar panel and catches floating leaves, bugs, and pollen in a 7-liter basket before they sink.
- The S2 Solar Vision heads back to an underwater solar dock when its battery falls below 20 percent, so charging no longer means lifting the robot out.
Which pool chores can a WYBOT robot take over?
Pool upkeep breaks down into a handful of recurring jobs: vacuuming settled debris off the floor, brushing the walls, scrubbing the waterline, skimming the surface, and looking after the cleaner itself. WYBOT builds a product for each of those jobs. The useful starting question is which chores you want gone, not which model carries the longest feature list.
| Chore | WYBOT products that handle it | Detail from the listings |
|---|---|---|
| Vacuuming the floor | Every underwater cleaner, A1 through S2 Solar Vision | The A1 is floor-only, with 2,280 GPH of dual-motor suction |
| Walls and the waterline | B1, C1, C2, C2 Vision, S2, S2 Solar Vision | The B1, C2, and C2 Vision include a Waterline-only mode |
| Skimming floating debris | F1 | 7 L basket with a 180 micron filter |
| Charging the cleaner | S2 Solar Vision | Returns to its solar dock below 20 percent battery |
Floor vacuuming: the job every WYBOT cleaner does
Sand, grit, and leaves that sink to the bottom are the baseline job for any pool robot, and every WYBOT underwater model handles them. The WYBOT A1 does this job and nothing else. It is built for above-ground and flat-bottom in-ground pools with a slope under 15 degrees, it rolls on water-propelled wheels instead of a dedicated drive motor, and it pauses for a few seconds at each wall to boost cleaning along the edge before heading back across the floor.
Where debris lands unevenly, such as under a row of trees, the camera models change how the floor gets cleaned. The C2 Vision and S2 Solar Vision use an onboard camera and an AI visual algorithm to locate debris, and WYBOT rates their AI Vision mode at up to 20 times faster than a standard pass. That mode works on the floor only; walls and the waterline are covered by the other cleaning modes.

Walls and the waterline: where the climbing models earn their keep
Brushing walls by hand is slow, tiring work, and wall coverage is the clearest dividing line in the WYBOT range. Apart from the A1, every WYBOT underwater cleaner at RoboticsSelect climbs the walls and cleans the waterline. The C1 listing explains how: its triple-motor system uses a water-jet reaction to hold the unit against the wall while it works the waterline.
Mode choice decides how that time is spent. The B1, C2, and C2 Vision include a Waterline-only mode, and the B1, C1, C2, and C2 Vision offer Wall then Floor, so a quick waterline pass can run between full cycles instead of a complete cleaning every time. On the compact B1, patented edge-to-edge side brushes work along walls and into the corners that round-bodied cleaners miss.
Surface debris: why the F1 works above the cleaner
Leaves, bugs, pollen, and twigs float for a while before they sink, and once they reach the floor they become the underwater cleaner's problem. The WYBOT F1 intercepts them at the surface. A 33 watt solar panel keeps it running through the day while it floats, dual brushless motors drive it along a V-shaped path, and ultrasonic radar sensors detect and avoid obstacles.
The F1 has two modes. Smart Mode works for 24 hours, alternating 10 minutes of cleaning with 10 minutes of rest, and Standard Mode cleans without a break for 8 hours. WYBOT notes that clearing the surface this way reduces what settles to the floor and eases the load on the pool's filter and pump.
Because the F1 cleans the surface only, it complements an underwater cleaner rather than replacing one. RoboticsSelect sells it on its own and in seven Full Pool Solution pairings with a WYBOT cleaner, grouped in the pool cleaner bundles collection.

Charging and retrieval: the chore that is easy to overlook
A cordless cleaner takes the cable out of the pool, but it adds a charging routine. The A1, C1, C2, C2 Vision, and S2 park themselves at the wall or edge when they finish, so retrieval is a lift rather than a hunt. Charge times vary by model: about 2.5 hours for the A1 and about three hours for the C2 and S2.
The WYBOT S2 Solar Vision removes that step. When its battery drops below 20 percent it returns to an underwater solar-powered charging dock and recharges there, with an included DC charger for a faster top-up and one-click start and return in the app. Because the dock sits at the waterline, the listing specifies it for in-ground pools. The F1, for its part, charges by solar while it floats; a DC charger for faster or indoor charging is sold separately.
What stays on your list
Automation shifts the work rather than ending it. Filters still need rinsing after cycles, and the C2 listing notes that its 10 micron fine filter clogs faster in heavily soiled water and may need a rinse partway through a cycle. The F1's basket needs emptying when it fills, and even the docked S2 Solar Vision has to be lifted out periodically to empty and rinse its filter box and sponge.
Water balance stays with you too. The warranty terms on most WYBOT listings exclude damage from running a unit in water chemistry outside the recommended range, so testing and adjusting the water remains part of the routine. Filters and brushes count as wear parts, and replacements for many WYBOT models are listed in the pool cleaner accessories collection.
Before you buy
Write down four things: the pool's surface area, whether the floor is flat or slopes more than 15 degrees, whether the pool is above-ground or in-ground, and which of the chores above you want automated. That list narrows the field quickly. A sloped floor rules out the A1, an above-ground pool rules out the dock-based S2 Solar Vision, and a surface full of leaves points to adding the F1.
Warranty, shipping, and support
RoboticsSelect is an authorized WYBOT dealer, so warranty support for every WYBOT product runs through our team, and we coordinate claims and repairs with WYBOT. The listings show 1-year warranties on the A1 and B1 and 2-year limited warranties on the C1, C2, C2 Vision, S2, and S2 Solar Vision; the F1's term is printed on the warranty card in its box and can vary by region. Warranty service requires proof of purchase.
We ship free anywhere in the contiguous 48 states; PO boxes, Alaska, Hawaii, Puerto Rico, and addresses outside the U.S. are outside our delivery area. Unopened, unused units qualify for the 30-day return window in our refund policy. Questions go to our U.S.-based, product-trained team at support@roboticsselect.com or (412) 415-7375.
The takeaway
WYBOT's range is easiest to understand as a set of tools for specific chores: a floor cleaner, climbing cleaners for walls and the waterline, a solar skimmer for the surface, and a docking cleaner for owners tired of charging. Pick the chores you want gone, match each one to the product that handles it, and compare the full lineup in the WYBOT collection at RoboticsSelect.
Products in this article
WYBOT C2 Cordless Robotic Pool Cleaner | 2026 Upgrade
WYBOT F1 Pool Skimmer Solar Powered Robotic Cleaner
WYBOT S2 Solar Vision Robotic Pool Cleaner
WYBOT B1 Cordless Robotic Pool Cleaner
FAQ
Can one WYBOT robot clean both the pool floor and the water surface?
Not on its own: the underwater cleaners work the floor and, except for the A1, the walls and waterline, while the F1 skimmer works only the surface. The Full Pool Solution bundles pair one of each so both levels are covered.
Does a WYBOT cleaner replace water testing and chemical balancing?
It removes debris; it does not balance the water. Most WYBOT warranty terms exclude damage from running a unit in water chemistry outside the recommended range, so testing and adjusting stays part of the routine.
Which WYBOT product needs the least handling between cleanings?
The S2 Solar Vision returns to its underwater solar dock when the battery drops below 20 percent and recharges there, and the F1 charges by solar while it floats. Both still need their filter box or basket emptied and rinsed from time to time.
Which WYBOT cleaners work in above-ground pools?
The listings rate the A1, C1, C2, C2 Vision, and S2 for above-ground as well as in-ground pools, and the F1 skimmer works in both. The S2 Solar Vision uses a waterline charging dock and is designed for in-ground pools.
Where do repair requests for a WYBOT product go?
To RoboticsSelect support: as an authorized WYBOT dealer, we handle warranty and repair requests and coordinate them with WYBOT. Have your order number or proof of purchase ready, since warranty service requires it.