Roborock Q5 Max+ Robot Vacuum Cleaner with Auto-Empty Dock

It is vacuum only. There is no water tank or mop cloth, so upkeep is limited to the dust bag, the washable filter, and the two rubber rollers, which makes it a good fit for carpet-heavy homes or anyone who already mops by hand. If you want the same DuoRoller Brush and auto-empty dock with mopping added, the Q8 Max+ is the step up within the Roborock line.

The DuoRoller Brush uses two counter-rotating rubber rollers that pass hair into the 770 ml bin instead of wrapping it; Roborock rates it at a 99 percent hair pick-up rate in Max+ mode, with 5,500 Pa of suction to pull debris out of carpet pile. One limit applies to every Roborock: the cliff sensors can read very dark or shag carpet as a drop, so the robot may avoid those rugs or report Error 4, and the sensors cannot be disabled.

The 2.5 L E12-rated bag holds up to 7 weeks of debris, and Roborock suggests replacing it about every 7 weeks depending on how much you vacuum. If the dock stops emptying well, check that the main brush and brush cover are seated with all four tabs hidden, that the air duct under the dock is clear, and that the bag handle is pushed all the way down. Replacement bags are a consumable and are not covered by warranty.

Auto-emptying only runs when the robot docks itself after cleaning: it will not start if you set the robot on the dock by hand, if the robot returned without cleaning, or during the Do Not Disturb window, which is 22:00 to 08:00 by default. Confirm auto-emptying is enabled in the app and the dustbin cover is installed. A steady red light on the dock usually means the dustbin cover or bag is not seated or the fan paused after overheating; unplug the dock, wait 30 minutes, and try again.

The Q5 Max+ connects to 2.4 GHz Wi-Fi only; 5 GHz networks are not supported, so on a dual-band router join the 2.4 GHz network by name. If pairing fails, make sure you selected your home network rather than the robot's own hotspot, re-enter the password, allow location and local network permissions for the Roborock app, turn off any VPN, and avoid WEP security or special characters in the network name. Without Wi-Fi the robot still runs full cleanups, spot cleans, and returns to the dock from its buttons; schedules, maps, and suction settings need the app.

It stores up to 4 maps with 3D map support and suggests no-go zones around trouble spots on each one. Build the first map by starting from the dock and letting the robot finish a full cleanup and return on its own; for another floor, switch the map setting to multi-floor, tap create new map, and carry only the robot upstairs. Amazon Alexa, Google Home, and Apple Siri Shortcuts are supported once the robot is linked in the Roborock app; for Alexa, say "Alexa, open robo rock" and then the command, such as "clean the bedroom", which works where the one-line phrasing sometimes does not.

The 5200 mAh battery runs up to 4 hours per charge, and the robot recharges and resumes if a large floor needs more. A full charge from empty takes under 6 hours, and off-peak charging in the app can shift recharging to cheaper hours. Roborock recommends leaving the robot on the dock whenever it is used at least weekly: once the battery is full only the main board draws power, so it does not shorten battery life. Off the dock the robot powers itself down after 24 hours of inactivity and has to be switched on by hand; if it will sit unused for several months, power it off.

Clean the main brushes every 2 weeks and replace them every 6 to 12 months; clean the side brush monthly and replace it every 3 to 6 months; empty and rinse the dustbin and washable filter weekly and replace the filter every 6 to 12 months. Wipe the sensors, charging contacts, and dock air duct as needed, and change the dust bag when it is full. Use the robot only between 39 and 104 F (4 to 40 C).

Put the dock on a hard, level floor against a wall with at least 1 ft (0.3 m) of clearance on each side and 3.3 ft (1 m) in front and above the auto-empty dock, and clear shoes, cords, and furniture legs from that area; Roborock lists obstacles near the dock as the usual reason the robot cannot dock, and a robot that was carried elsewhere rebuilds its map and may need to be placed on the dock by hand. Wipe the signal window on the front of the dock and the robot's front sensor, which it uses to line up. When an error occurs the robot's power light flashes red, the app shows a pop-up naming the cause, and a voice alert may sound; follow the prompt, which usually means clearing hair from the main brush or wheels, wiping the cliff sensors, or washing and fully drying the filter. A repeated Error 13 means dirty charging contacts: wipe them with a cloth dampened with rubbing alcohol, unplug the dock for two minutes, and try another outlet.

Roborock covers new products such as the Q5 Max+ with a one-year limited warranty from the purchase date against defects in materials and workmanship. Consumables such as filters, brushes, mop cloths, and dust bags are not covered unless a defect in a non-consumable part damaged them, and normal wear, cosmetic damage, misuse, and commercial use are excluded. Keep your receipt: without proof of purchase the warranty period defaults to three months from the factory ship date. Warranty and technical support run through Roborock US at support@roborock.com or 1-855-960-4321 (24/7); RoboticsSelect is an authorized dealer, ships free within the contiguous U.S., and accepts standard returns within 30 days.