Roborock Q7 M5+ Robot Vacuum and Mop with Auto- Empty Dock (Upgraded from Q5 Max+)

After each cleanup the dock pulls the robot's bin contents into a sealed 2.7 L dust bag, good for up to 7 weeks of cleaning before a change; Roborock suggests replacing the bag about every 7 weeks depending on use. The dock measures 8.4 x 7.0 x 10.2 inches, runs on 100 to 120 V in the US, and needs no plumbing. If emptying weakens, check that the main brush and brush cover are seated, that the air duct is clear, and that the bag handle is pushed all the way down.

Auto-emptying only runs when the robot docks itself after cleaning: it will not start if you set the robot on the dock by hand, if the robot came back without cleaning, or during the Do Not Disturb period (22:00 to 08:00 by default). Confirm auto-emptying is enabled in the app and the dustbin cover is installed. A steady red dock light usually means the cover or bag is not seated or the fan paused after overheating; unplug the dock for 30 minutes and retry.

The Dual Anti-Tangle System pairs a JawScrapers comb main brush with an anti-tangle side brush; Roborock rates it at a 95 percent hair pickup rate with the brushes certified by TÜV Rheinland for anti-entanglement, Auto Boost raises suction to as much as 10,000 Pa when carpet is detected, and a 2 cm (0.8 in) climbing ability gets it over typical thresholds. It does not lift its mop: Roborock lists mop module lifting as an additional feature of the Q10 series, so attach the mop module only for hard-floor runs or keep carpeted rooms out of mopping passes with no-go zones in the app. The mop offers three water flow levels and a DEEP+ high-intensity mode for dried-on spots. Very dark or shag carpet can trigger the cliff sensors as if it were a drop, so the robot may avoid those rugs.

Against the Q5 Max+ generation it nearly doubles suction to 10,000 Pa and adds mopping, but it uses a smaller 3,200 mAh battery, so it suits small to mid-size homes rather than very large single floors. The Q7 M5 is the same robot without the auto-empty dock. The Q10 X5+ keeps the auto-empty dock and adds a 5,200 mAh battery, a structured-light obstacle sensor, and a mop that lifts on carpet.

Expect about 1 hour per 20 percent and 3 to 4 hours from 20 to 100 percent; Roborock uses a gentler charging current to extend battery life. When the battery runs low mid-clean the robot docks, charges to 80 percent, and resumes where it stopped. Leave it on the dock between runs; off the dock it powers itself down after 24 hours of inactivity.

The Q7 M5+ connects to 2.4 GHz Wi-Fi only; 5 GHz is not supported, so choose the 2.4 GHz network on a dual-band router. When the Roborock app asks you to scan a QR code, look under the top cover or dustbin or on top of the machine; if you cannot find it, tap Search for Device and then No QR code found to continue pairing. If the connection still fails, re-enter the password, allow location and local network permissions for the app, switch off any VPN, and avoid WEP security or special characters in the network name.

Use clean, cold water; hot water can deform the tank. Roborock says to add only its own branded floor cleaner, diluted at 1:300, because foam from other cleaners can block the filter and corrode parts. Do not add disinfectant or essential oils.

Clean the main brush every 2 weeks and replace it every 6 to 12 months; clean the side brush monthly and replace it every 3 to 6 months; rinse the washable filter every 2 weeks and replace it every 6 to 12 months. Wash the mop cloth after each use and replace it every 3 to 6 months, wipe the sensors and charging contacts as needed, and change the dust bag when full. Operate only between 39 and 104 F (4 to 40 C).

Put the dock on a hard, level floor against a wall with open floor in front of the dock and clearance on both sides so the robot can line up straight, and clear shoes, cords, and furniture legs from that area; Roborock lists obstacles near the dock as the usual reason the robot cannot dock, and a robot that was carried elsewhere rebuilds its map and may need to be placed on the dock by hand. Wipe the signal window on the front of the dock and the robot's front sensor, which it uses to line up. When an error occurs the robot's power light flashes red, the app shows a pop-up naming the cause, and a voice alert may sound; follow the prompt, which usually means clearing hair from the main brush or wheels, wiping the cliff sensors, or washing and fully drying the filter. A repeated Error 13 means dirty charging contacts: wipe them with a cloth dampened with rubbing alcohol, unplug the dock for two minutes, and try another outlet.

Roborock covers new products such as the Q7 M5+ with a one-year limited warranty from the purchase date against defects in materials and workmanship. Consumables such as filters, brushes, mop cloths, and dust bags are not covered unless a defect in a non-consumable part damaged them, and normal wear, cosmetic damage, misuse, and commercial use are excluded. Keep your receipt: without proof of purchase the warranty period defaults to three months from the factory ship date. Warranty and technical support run through Roborock US at support@roborock.com or 1-855-960-4321 (24/7); RoboticsSelect is an authorized dealer, ships free within the contiguous U.S., and accepts standard returns within 30 days.